DSF/ISO/DIS 2859-2 ( Forslag )

Metoder for stikprøveinspektion ved måling med alternativ variation – Del 2: Stikprøveplaner opstillet efter utilfredsstillende kvalitet (LQ) for inspektion af enkeltstående partier


Status:
Forslag
Type:
Standard
Sprog:
EN

Beskrivelse

This part of ISO 2859 specifies an acceptance sampling system for inspection by attributes indexed by
limiting quality (LQ). The sampling system is used for lots in isolation (isolated sequences of lots, an
isolated lot, a unique lot or a short series of lots), where switching rules, such as those of ISO 2859-1, are
not applicable. Inspection levels, as provided by ISO 2859-1 to control the relative amount of inspection,
are not provided by ISO 2859-2. There is little doubt that in many industrial situations, in which
switching rules might be used, they are not applied for a number of reasons or excuses, not all of which
may might be valid:
a) production is intermittent (not continuous);
b) production is from several different sources in varying quantities, i.e. “job lots”;
c) lots are isolated;
d) lots are resubmitted after inspection.
The sampling plans in this part of ISO 2859 are indexed by a series of specified values of limiting quality
(LQ), where the consumer’s risk (the probability of acceptance at the LQ) is usually below 0,10 (10 %),
except in some instances.
This part of ISO 2859 is intended both for inspection for nonconforming items and for inspection for
nonconformities per 100 items.
This part of ISO 2859 is to be used when the supplier and the consumer both regard the lot to be in
isolation. That is, the lot is unique in that it is the only one of its type produced. It may can also be used
when there is a series of lots too short for switching rules to be applied.

Antal sider: 44

Internationale relationer: ISO/DIS 2859-2 IDT

ICS: 03.120.30 - Anvendelse af statistiske metoder

Varenummer: M327333


Udvalg og komiteer

Komite

  • ISO/TC 69/SC 5
  • ISO/TC 69/SC 5/WG 2

Dansk udvalg

DS/S-238