DSF/prEN ISO 8062-3 ( Forslag )

Geometriske produktspecifikationer (GPS) – Dimensionstolerancer og geometriske tolerancer for formstøbte dele – Del 3: Generelle dimensionstolerancer og geometriske tolerancer samt bearbejdningstillæg for støbte dele


Status:
Forslag
Type:
Standard
Sprog:
Engelsk

Beskrivelse

This part of ISO 8062 specifies general dimensional and geometrical tolerances as well as machining
allowance grades for castings as delivered to the purchaser in accordance with ISO 8062-2. It is
applicable for tolerancing of dimensions and geometry of castings in all cast metals and their alloys
produced by various casting manufacturing processes.
This part of ISO 8062 applies to both general dimensional and general geometrical tolerances (referred
to in or near the title block of the drawing), unless otherwise specified and where specifically referred
to on the drawing by one of the references in clause 9.
The dimensional tolerances covered by this part of ISO 8062 are tolerances for linear dimensions.
The geometrical tolerances covered by this part of ISO 8062 are: Tolerances for straightness, flatness,
roundness, parallelism, perpendicularity, symmetry and coaxiality.
This part of ISO 8062 can be used for the selection of tolerance values for individual indications.
NOTE – This part of ISO 8062 does not apply to 3D CAD models used without indicated dimensions.


Antal sider: 38

Internationale relationer : prEN ISO 8062-3 IDT ISO/DIS 8062-3 IDT

ICS: 17.040.10 - Tolerancer og pasninger

Varenummer: M334933


Udvalg og komiteer

Komite

  • CEN/TC 190
  • CEN/TC 190
  • CEN/TC 190
  • ISO/TC 213
  • ISO/TC 213
  • ISO/TC 213
  • ISO/TC 213
  • ISO/TC 213/WG 9
  • ISO/TC 213/WG 9
  • ISO/TC 213/WG 9
  • ISO/TC 213/WG 9

Dansk udvalg

DS/S-812